500 T press for rubbert coating of moulds for ceramics

Maximum clamping force 500 T
Dimensions of platens 1500 x 1500 mm
Maximum daylight between platens 600 mm
Stroke of the movable platen 600 mm
The press is used for applying the resin/rubber coating to moulds for ceramic products (i.e. tiles, etc.)
The press features a self-teaching system able to automatically learn the "zero position" of the moulds (closing point of the mould). The self-teaching mode is activated only when the press is running in manual mode. The setting of the "zero position" is possibile thanks to an hydraulic device that allows for closing of moulds using a zero pressure, thus avoiding any damage to the shearing edges of the cavity of the mould. After setting the "zero position", the press will achieve this position also while running on automatic mode, since the system will automatically set the proper position independently from the hydraulic pressure required. This system allows for higher quality of the resin/rubber coating, thanks to the high repeatibilty of the process and also since it avoids costly break-downs of the ejection frame of the moulds.